Remove the processor (trained technician only)

Follow instructions in this section to remove the processor. The procedure must be executed by a trained technician.

About this task

S002

CAUTION

The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

Attention

• Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.
• If the server is in a rack, remove it from the rack. See Remove the server from rack.
• Remove any locking device that secures the server, such as a Kensington lock or a padlock.
• Place the server on its side with the cover up.

Procedure

1. Make preparation for this task.
   1. Remove the server cover. See Remove the server cover.
      Attention

      The heat sinks and processor could be very hot. To avoid burning yourself, wait for a few minutes after turning off the server before you remove the server cover.
   2. If applicable, remove the optical drive. See Remove an optical drive.
   3. If applicable, remove the optical drive cage. See Remove an optical drive cage.
   4. Remove the heat sink and fan module. See Remove the heat sink and fan module (trained technician only).
2. Remove the processor.
   1. Gently pull the handle away from the processor retainer.
   2. Lift the handle.
   3. Lift the socket retainer to the fully open position as illustrated.
   4. Hold the processor by both sides and gently lift it away from the processor socket.
   Note

   1. Do not touch the gold contacts on the bottom of the processor.

   2. Keep the processor socket clean from any object to prevent possible damages.

   Figure 1. Removing the processor