Removing a DIMM
Use this information to remove a dual inline memory module (DIMM). The upper and lower compute nodes each have their own dedicated DIMMs.
Before you remove a DIMM, complete the following steps:
- Read Safety and Installation guidelines.
- If the Flex System x222 Compute Node is installed in a chassis, remove it (see Removing a compute node from a chassis for instructions).
- Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with the bezel pointing toward the left.
After you install or remove a DIMM in the upper or lower compute node, you must change and save the new configuration information for that compute node by using the Setup utility. When you turn on the compute node where DIMMs have been installed or removed, a message indicates that the memory configuration has changed. Start the Setup utility and select Save Settings (see Using the Setup utility for more information) to save changes.
To remove a DIMM, complete the following steps.
If you are instructed to return the DIMM, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.
Give documentation feedback