Skip to main content

Replacing the simple-swap SATA drive backplate assembly

Use this information to replace the simple-swap drive SATA drive backplate assembly.

To install the replacement simple-swap SATA drive and backplate assembly, complete the following steps:
Note
The simple-swap SATA drive and backplate assembly must be installed in the backplane slot closest to the information panel and the SATA drive must be installed in the drive-bay closest to the information panel. The backplate assembly cable connects to the CD/DVD-ROM drive connector on the system board.
  1. Read the safety information that begins in Safety and Installation guidelines.
  2. Align the tabs on the bottom of the drive backplate with the backplate slots on the bottom of the backplane cage.
    Figure 1. Simple-swap SATA drive backplate assembly installation
    Simple-swap SATA drive backplate assembly installation
  3. Insert the drive backplate tabs into the slots on the bottom of the backplate cage and push down the retention latch on top of the drive cage; then, rotate the drive backplate assembly forward until the backplate is latched.
  4. Reinstall the drive and filler panel and plastic drive-bay spacer.
  5. Install the cover (see Replacing the server top cover).
  6. Reconnect the power cords and any cables that you removed.
  7. Turn on the peripheral devices and the server.