Skip to main content

Removing the operator information panel assembly

Use the information to remove the operator information panel assembly.

To remove the operator information panel, complete the following steps.

  1. Read the safety information that begins in Safety and Installation guidelines.
  2. Turn off the server (see Turning off the server) and all attached peripheral devices. Disconnect all power cords; then, disconnect all external cables as necessary to replace the device.
  3. Remove the server cover (see Removing the server top cover).
  4. Disconnect the cable from the back of the operator information panel assembly.
  5. Push the blue points on the rear of the operator information panel to the front of the server.
    Figure 1. Operator information panel assembly removal
    Operator information panel assembly removal
  6. From the front of the server, carefully pull the assembly out of the server.
  7. If you are instructed to return the operator information panel assembly, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.