Replacing a USB embedded hypervisor flash device

Use this information to install a USB embedded hypervisor flash device.

1. Read the safety information that begins in Safety and Installation guidelines.
2. Align the USB flash device with the connector on the system board and push it into the connector until it is firmly seated.
3. Slide the lockbar toward the riser-card assembly to the locked position until it is seated firmly.
   Figure 1. USB hypervisor flash device installation
   
   
4. Reconnect the power cord and any cables that you removed.
5. Install PCI riser-card assembly 1 (see Replacing a PCI riser-card assembly).
6. Install the air baffle (see Replacing the air baffle).
7. Install the cover (see Replacing the server top cover).
8. Reconnect the power cord and any cables that you removed.
9. Turn on the peripheral devices and the server.