Skip to main content

Thermal grease

The thermal grease must be replaced whenever the heat sink has been removed from the top of the microprocessor and is going to be reused or when debris is found in the grease.

When you are installing the heat sink on the same microprocessor that is was removed from, make sure that the following requirements are met:
  • The thermal grease on the heat sink and microprocessor is not contaminated.
  • Additional thermal grease is not added to the existing thermal grease on the heat sink and microprocessor.
Note

To replace damaged or contaminated thermal grease on the microprocessor and heat sink, complete the following steps:

  1. Place the heat sink on a clean work surface.
  2. Remove the cleaning pad from its package and unfold it completely.
  3. Use the cleaning pad to wipe the thermal grease from the bottom of the heat sink.
    Note
    Make sure that all of the thermal grease is removed.
  4. Use a clean area of the cleaning pad to wipe the thermal grease from the microprocessor; then, dispose of the cleaning pad after all of the thermal grease is removed.
    Figure 1. Thermal grease distribution
    Thermal grease distribution

  5. Use the thermal-grease syringe to place 9 uniformly spaced dots of 0.02 mL each on the top of the microprocessor. The outermost dots must be within approximately 5 mm of the edge of the microprocessor; this is to ensure uniform distribution of the grease.
    Figure 2. Syringe
    Syringe

    Note
    If the grease is properly applied, approximately half of the grease will remain in the syringe.
  6. Install the heat sink onto the microprocessor as described in Installing an additional microprocessor and heat sink.