Skip to main content

Rear I/O and OCP module cable routing

Follow instructions in this section to install and route the cables for the rear I/O module and OCP module.

Note
  • Depending on the specific configuration, the information in this topic might not apply to your node.

  • Connections between connectors; 1↔1, 2↔2, 3↔3, ... n↔n

  • When routing the cables, make sure that all cables are routed appropriately through the corresponding cable guides and cable clips.

  • Strictly observe the following instructions to avoid damaging cable sockets on the system board. Any damage to the cable sockets might require replacing the system board.

    • Connect cable connectors vertically or horizontally in alignment with the orientations of the corresponding cable sockets, avoiding any tilt.

    • To disconnect cables from the system board, do as follows:

      1. Press and hold all latches, release tabs, or locks on cable connectors to release the cable connectors.

      2. Remove the cable connectors vertically or horizontally in alignment with the orientations of the corresponding cable sockets, avoiding any tilt.
        Note
        The cable connectors might look different from those in the illustration, but the removal procedure is the same.






Figure 1. Cables for the rear I/O module and OCP module

From (system board)ToCable
1a OCP power and sideband connector1 Node (secured with screws)MCIO x8 (270 mm)to GenZ 4C+ OCP connector
1b OCP signal connectorMCIO x16 (450 mm)
2 Rear I/O signal connector2 Rear I/O signal connector (on the rear I/O module)Low-profile SlimSAS x8 to SlimSAS x8 (915 mm)
Note
When connecting the rear I/O cable to the rear I/O module, make sure to secure the attached grounding cable with a screw.
Figure 2. Installation of the rear I/O cable and grounding cable
Installation of the rear I/O cable and grounding cable