Remove the firmware and RoT security module

Procedure

1. Make preparations for this task.
   1. Perform OneCLI commands to back up the UEFI settings. See OneCLI commands that save configuration settings.
   2. Perform both OneCLI commands and XCC actions to back up the XCC settings. See OneCLI commands that save configuration settings and Using XCC to back up the BMC configuration.
   3. Power off the node (see Power off the node); then, disconnect all external cables from the node.
      Note

      If necessary, press the release clip with a flat-head screwdriver to remove an external network cable from the rear of a 2U node.
      
      
   4. Remove the node from the chassis (see Remove a node from the chassis); then, carefully lay the node on a flat, static-protective surface, orienting the node with the front toward you.
      Note

      • When removing the node, note the node tray number and make sure to install the node in the same tray from which it was removed. Reinstalling the node into a different tray requires the node to be reconfigured.
      • For safety, make sure to hold the node with both hands when lifting the node.
   5. Remove the top cover (see Remove the top cover).
   6. Disconnect all the cables from the drive backplane; then, remove the drive cage assembly from the node and place it on a flat, static-protective surface (see Remove the drive cage assembly).
2. Locate the Firmware and RoT security module connector on the system board.
   Figure 1. Location of the Firmware and RoT security module
   
   
3. Remove the firmware and RoT security module from the system board.
   1. Loosen the two screws that secure the firmware and RoT security module on the system board.
   2. Lift the firmware and RoT security module away from the system board.
      Figure 2. Removal of the Firmware and RoT security module