Skip to main content

Remove the node from the wall or the ceiling

Follow instructions in this section to remove the node from the node sleeve, as well as the node sleeve from the wall mount/ceiling mount.

About this task

To avoid potential danger, make sure to read and follow the safety information.

  • S002
    disconnect all power
    CAUTION
    The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

Attention

　

Remove the node from the node sleeve​

Note

  • If applicable, unlock any locking device that secures the node to the node sleeve, such as a Kensington lock.

  • Depending on the specific configuration, the node or security bezel might look different from the illustrations in this section.

Procedure

  1. If applicable, remove the security bezel from the node sleeve.
    1. Use the key to unlock the security bezel.
    2. Press the release tab and pivot the security bezel and pivot the security bezel outward.
    3. Remove the security bezel from the node sleeve

      　

      Figure 1. Removal of the security bezel from a node sleeve
      Removing the security bezel from a node sleeve
  2. Power off the server and disconnect all external cables and power cords (see Power off the server).
  3. Remove the node from the node sleeve.
    1. Loosen the two thumbscrews on the side of the node sleeve.
    2. Slide the node out of the node sleeve.

      　

      Figure 2. Removal of a node from a node sleeve
      Node removal from sleeve

　

After this task is completed

  • Carefully lay the node on a flat, static-protective surface.

Back to top

　

Remove the node sleeve from the wall​

Procedure

  1. Remove the four screws as shown; then, remove the node sleeve from the wall.

    　

    Figure 3. Removal of node sleeve directly from the wall
    Node sleeve removal
  2. (Optional) If necessary, remove the wall anchors from the wall.

    　

    Figure 4. Removal of the wall anchors

　

After this task is completed

  • If you are instructed to return the component, follow all of the packaging instructions and use any packaging materials for shipping that are supplied to you.

Back to top