Node component replacement
Follow instructions in this section to remove or install components from or to the node.
- Air baffle replacement
Follow instructions in this section to remove or install an air baffle. - CMOS battery (CR2032) replacement
Follow instructions in this section to remove or install a CMOS battery. - Drive and backplane replacement
Follow instructions in this section to remove or install the components of a drive assembly, including the hot-swap drives, drive cage, and drive backplane(s). - Fan module replacement
Follow instructions in this section to remove or install a fan module . - Front operator assembly replacement
Follow instructions in this section to remove or install a front operator assembly. - Internal power supply unit (AC PMB) replacement
Follow instructions in this section to remove or install a ThinkEdge 500W 230V/115V Non-Hot Swap Power Supply (internal power supply unit, also called AC PMB). - Intrusion switch with cable replacement
Follow instructions in this section to remove or install an intrusion switch with cable. - Keylock switch with cable replacement
Follow instructions in this section to remove or install an anti-tampering keylock switch with cable. - M.2 boot drive replacement
Follow instructions in this section to remove or install an M.2 boot drive from or to the I/O module board. - Memory module replacement
Follow instructions in this section to remove or install a memory module. - MicroSD card replacement
Follow instructions in this section to remove or install a MicroSD card from or to the system board. - Power input board (PIB) module replacement
Follow instructions in this section to remove or install a power input board (PIB) module. - Power module board (PMB) replacement
Follow instructions in this section to remove or install a power module board (PMB). - Processor heat sink replacement (trained technician only)
Follow instructions in this section to remove or install a processor heat sink. This procedure must be executed by a trained technician. - Rubber feet replacement
Follow instructions in this section to remove or install the rubber feet (4 rubber pads). - System-board assembly replacement (trained technician only)
Follow instructions in this section to remove or install the system-board assembly, including the system board, bridge board, I/O module board (aka. LOM package), and front I/O bezel. This procedure must be executed by a trained technician. - Top cover replacement
Follow instructions in this section to remove or install the top cover.
Give documentation feedback