Install the dust filter to the shipping bracket

Follow instructions in this section to install the dust filter to the shipping bracket.

About this task

Attention

Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
Depends on the operating environment, check the status of the dust filter at least every 3 months to make sure it is functional.

SE360 V2 2U2N Enclosure supports a set of dust filters installed in the front shipping bracket. The dust filter set has a Minimum Efficiency Rating Value (MERV) of 5, per ASHRAE 52.2-2017 / 80% Average Arrestance per ASHRAE 52.1-1992.

Procedure

Insert the dust filters into the corresponding slots of shipping bracket until they are firmly seated.
Note
Depending on the configuration, some parts in the following illustration might not come with the system.
Figure 1. Installing the dust filters
Push the shipping bracket toward the enclosure until it is firmly seated.
Figure 2. Installing the shipping bracket
Secure the captive screws of the shipping bracket.
1. Fasten the captive screw on the top.
2. Fasten the four captive screws on both sides.
3. Fasten the three captive screws on the front.
Figure 3. Fastening the screws

Give documentation feedback