Skip to main content

Remove the CMOS battery (CR2032)

Use this information to remove the CMOS battery.

About this task

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
S004
Attention
CAUTION

When replacing the lithium battery, use only Lenovo specified part number or an equivalent type of battery recommended by the manufacturer. If your system has a module containing a lithium battery, replace it only with the same module type made by the same manufacturer. The battery contains lithium and can explode if not properly used, handled, or disposed of.

Do not:
  • Throw or immerse into water
  • Heat to more than 100°C (212°F)
  • Repair or disassemble

Dispose of the battery as required by local ordinances or regulations.

S005
Attention
CAUTION
The battery is a lithium ion battery. To avoid possible explosion, do not burn the battery. Exchange it only with the approved part. Recycle or discard the battery as instructed by local regulations.
Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.

  • If the server is installed in a rack, remove the server from the rack.

  • Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

  • When replacing the CMOS battery, you must replace it with another CMOS battery of the same type from the same manufacturer.

  • Do not make the CMOS battery come in contact with a metal surface when replacing it. The contact with metal surface, such as server side, can cause damage to the battery.

  • After replacing the CMOS battery, make sure to reconfigure the server and reset system date and time.

The following notes describe information that you must consider when replacing the battery.

  • Lenovo has designed this product with your safety in mind. The lithium battery must be handled correctly to avoid possible danger. If you replace the battery, you must adhere to the following instructions.

  • If you replace the original lithium battery with a heavy-metal battery or a battery with heavy-metal components, be aware of the following environmental consideration. Batteries and accumulators that contain heavy metals must not be disposed of with normal domestic waste. They will be taken back free of charge by the manufacturer, distributor, or representative, to be recycled or disposed of in a proper manner.

  • After you replace the battery, you must reconfigure the solution and reset the system date and time.

Procedure

  1. Remove the top cover. See Remove the top cover.
  2. Locate the CMOS battery on the system board.
    Figure 1. CMOS battery location
    CMOS battery location
    1 CMOS battery location
  3. Remove the CMOS battery.
    Figure 2. CMOS battery removal
    CMOS battery removal
    Attention
    Do not use excessive force to tilt or push the battery, it might damage the socket.
    1. Press the battery clip in the direction as shown.
    2. Carefully tilt and lift CMOS battery out of the socket.

After you finish

  1. Install a replacement unit. See Install the CMOS battery (CR2032).

  2. If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

Demo video

Watch the procedure on YouTube