Skip to main content

Remove the front I/O assembly

Use this information to remove the front I/O assembly.

About this task

The following illustrates how to remove the front I/O assembly with diagnostics panel. You can remove other front I/O assemblies in the same way.

Attention

  • Read Installation guidelines to ensure that you work safely.

  • Power off the server and disconnect all power cords for this task.

  • Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.

Procedure

  1. Remove the top cover. See Remove the top cover.
  2. If the security bezel is installed, remove it. See Remove the security bezel.
  3. Disconnect the front I/O cables from the system board.
    1. Press the release tab to release the connector.
    2. Disengage the connector from the cable socket.
      Note

      • Failing to release the tab before removing the cables will damage the cable sockets on the system board. Any damage to the cable sockets might require replacing the system board.

      • The connector on your server may look slightly different from the following illustration.

      Figure 1. Disconnecting front I/O cable

  4. Remove the front I/O assembly.
    Figure 2. Removal of the front I/O assembly
    Removal of the front I/O assembly

    1. Remove the screws that secure the front I/O assembly.
    2. Slide the front I/O assembly out of the front chassis.

After you finish

If you are instructed to return the old front I/O assembly, follow all packaging instructions and use any packaging materials that are provided.

Demo video

Watch the procedure on YouTube