Install the intrusion switch
Follow the instructions in this section to install the intrusion switch.
About this task
Attention
Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.
Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-sensitive components in their static-protective packages until installation, and handling these devices with an electrostatic-discharge wrist strap or other grounding system.
Procedure
- Install the intrusion switch onto the fan cage.Figure 1. Installing the intrusion switch
Insert the intrusion switch into the holder on the fan cage and push it in the direction as shown until it is fully seated.
Fix the intrusion switch cable into the cable clip.
Route the cable into the fan cage through the pre-cut slots on the foam and fan cage bottom.
Insert the intrusion switch connector into the connector keyhole, and move it in the shown direction until it is fully seated.NoteEnsure that the intrusion switch cable is routed through the cable clip and the pre-cut slots on the foam and fan cage bottom. Otherwise, the cable may slide under the fan cage, the contact surface between the fan cage and the system board assembly may get uneven, and the fan connection may get loose.
Give documentation feedback