Skip to main content

Remove a memory module

Use this information to remove a memory module.

About this task

Attention
  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
  • Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.
  • Make sure to remove or install memory module at least 20 seconds after disconnecting power cords from the system. It allows the system to be completely discharged of electricity and safe for handling memory module.
  • If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover, or remove the server from the rack. See Remove the server from rack.
  • If you are not installing a replacement memory module to the same slot, make sure you have memory module filler available.
  • Memory modules are sensitive to static discharge and require special handling. Refer to the standard guidelines for Handling static-sensitive devices.
    • Always wear an electrostatic-discharge strap when removing or installing memory modules. Electrostatic-discharge gloves can also be used.
    • Never hold two or more memory modules together so that they do not touch each other. Do not stack memory modules directly on top of each other during storage.
    • Never touch the gold memory module connector contacts or allow these contacts to touch the outside of the memory module connector housing.
    • Handle memory modules with care: never bend, twist, or drop a memory module.
    • Do not use any metal tools (such as jigs or clamps) to handle the memory modules, because the rigid metals may damage the memory modules.
    • Do not insert memory modules while holding packages or passive components, which can cause package cracks or detachment of passive components by the high insertion force.
Important
Remove or install memory modules for one processor at a time.

Procedure

Attention

Make sure to remove or install memory module at least 20 seconds after disconnecting power cords from the system. It allows the system to be completely discharged of electricity and safe for handling memory module.

  1. Make preparation for this task.
    1. Remove the top cover. See Remove the top cover.
    2. Remove the air baffle. See Remove the air baffle.
    3. Locate the memory module slots and determine which memory module to be removed.
      Figure 1. Memory modules and processors layout
      Memory module and processor location
  2. If necessary, remove a cable guide from the chassis wall to access the memory module slots.
    Figure 2. Cable guide removal
    Cable guide removal
  3. Remove the memory module from the slot.
    Attention
    To avoid breaking the retaining clips or damaging the memory module slots, handle the clips gently.
    1. Gently open the retaining clip on each end of the memory module slot.
    2. Grasp the memory module at both ends and carefully lift it out of the slot.
    Figure 3. Memory module removal
    Memory module removal
After you finish
  1. A memory module slot must be installed with a memory module or a memory module filler. See Install a memory module.
  2. If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

Demo video

Watch the procedure on YouTube