Skip to main content

Install a rear hot-swap fan

Follow instructions in this section to install a rear hot-swap fan.

About this task

Attention
  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
  • Make sure to replace a defective fan with another unit of the exact same type.
  • Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.
  • The following illustrations show the rear fan numbering:
    Figure 1. Rear fan numbering
    Rear fan numbering

Procedure

  1. Make sure the airflow direction label on the fan is facing up; then, align the fan with the fan socket.
  2. Press and hold the orange latch; then, slide the fan into the socket until it clicks into place.
    Figure 2. Rear primary fan installation
    Rear primary fan installation

After you finish

Complete the parts replacement. See Complete the parts replacement.