Skip to main content

Install an H100/H200 GPU air duct

Follow instructions in this section to install an H100/H200 GPU air duct. The procedure must be executed by a trained technician.

About this task

Attention
  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
  • Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.
  • Two people and one lifting device on site that can support up to 400 lb (181 kg) are required to perform this procedure. If you do not already have a lifting device available, Lenovo offers the Genie Lift GL-8 material lift that can be purchased at Data Center Solution Configurator. Make sure to include the Foot-release brake and the Load Platform when ordering the Genie Lift GL-8 material lift.
  • Do not mix up left and right GPU air ducts.
    • Install the GPU air duct with stamp “LH” on the left side (when looking at the 8U GPU shuttle from the front).
    • Install the GPU air duct with stamp “RH” on the right side (when looking at the 8U GPU shuttle from the front).

Procedure

  1. Make sure the stamp “TOP” on the GPU air duct is facing up.
  2. Hold the two handles on the top of the GPU air duct; then, insert the GPU air duct into the area between the two outermost GPU and heat sink modules until it is seated in place.
    Figure 1. GPU air duct installation
    GPU air duct installation

After you finish

  1. Reinstall the power complex. See Install the power complex.
  2. Reinstall the 8U GPU shuttle. See Install the 8U GPU shuttle.
  3. Reinstall all the 2.5-inch hot-swap drives or drive bay fillers (if any) into the drive bays. See Install a 2.5-inch hot-swap drive
  4. Reinstall all the front fans. See Install a front hot-swap fan.
  5. Reinstall all the power supply units. See Install a hot-swap power supply unit.
  6. Complete the parts replacement. See Complete the parts replacement.