Server models with eight 3.5-inch hot-swap drives (hardware RAID)

Use this section to understand the cable routing for server models with eight 3.5-inch hot-swap drives (hardware RAID).

Note

Ensure that all cables are routed through the correct cable clips.

Figure 1. Cable routing for server models with eight 3.5-inch hot-swap drives (hardware RAID)

Cable	From	To
1 Power cable for backplane 1	Power connector on backplane 1	Backplane 1 power connector on the system board
2 SAS signal cable for backplane 1	SAS connector on backplane 1	An available connector on the RAID adapter
3 Power cable for backplane 2	Power connector on backplane 2	Backplane 2 power connector on the system board
4 SAS signal cable for backplane 2	SAS connector on backplane 2	An available connector on the RAID adapter