Skip to main content

Install the M.2 drive retainer

Follow instructions in this section to install the retainer for M.2 drive 2.

About this task

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

Procedure

  1. Align the M.2 drive retainer with the three slots on the chassis, and lower the retainer into the chassis; then, slide the retainer toward the 2.5-inch drive cage to secure it in place.
    Figure 1. Installing the M.2 drive retainer
    Installing the M.2 drive retainer
  2. Install an M.2 drive. See Install an M.2 drive.
After you finish

  1. If applicable, reinstall the 2.5-inch drive to bay 1. See Install a simple-swap drive (bay 0-1).

  2. Complete the parts replacement. See Complete the parts replacement.