Install the power button with LED

Follow instructions in this section to install the power button with LED.

About this task

S002

CAUTION

The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

Attention

• Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

Procedure

1. Install the power button with LED.
   1. Tilt the power button, and insert the tab on the bottom of the power button cable into the slot.
   2. Push the power button into the slot until it snaps into place.
      Figure 1. Installing the power button with LED
      
      
2. Install the front I/O bracket.
   1. There is a small tab on the right side of the front I/O bracket. Place the tab behind the front I/O bracket slot on the chassis.
   2. Align the guide hole and screw hole on the front I/O bracket with the guide pin and screw slot on the chassis; then, install the front I/O bracket to the chassis. Make sure the small tab on the right side of the front I/O bracket is placed behind the chassis.
      Figure 2. Installing the front I/O bracket to the chassis
      
      
   3. Fasten the screw to secure the front I/O bracket to the chassis.
      Figure 3. Securing the front I/O bracket to the chassis
      
      
3. Connect the power button cable to the system board. See Internal cable routing.