Remove the power button with LED

Follow instructions in this section to remove the power button with LED.

S002

CAUTION

The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

Procedure

1. Make preparation for this task.
   1. Remove the server cover. See Remove the server cover.
      Attention

      The heat sink and processor could be very hot. To avoid burning yourself, wait for a few minutes after turning off the server before you remove the server cover.
   2. Remove the front bezel. See Remove the front bezel.
2. Remove the power button cable from the system board.
   Attention

   To avoid damaging the system board, make sure to follow the instructions in Internal cable routing when disconnecting cables from the system board.
3. Remove the screw that secures the front I/O bracket to the chassis.
   Figure 1. Removing the screw that secures the front I/O bracket
   
   
4. Remove the front I/O bracket.
   1. Rotate the left end of the front I/O bracket away from the chassis.
   2. Remove the front I/O bracket from the chassis.
      Figure 2. Removing the front I/O bracket from the chassis
      
      
5. Remove the power button with LED from the front I/O bracket.
   1. Press the release tab on the power button to release it from the front I/O bracket.
   2. Remove the power button from the front I/O bracket.
      Figure 3. Removing the power button with LED