Skip to main content

Remove the drive cage (bay 3)

Follow instructions in this section to remove the bay 3 drive cage.

About this task

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Attention
  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
  • Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.
  • Remove any locking device that secures the server, such as a Kensington lock or a padlock.
  • Place the server on its side with the cover up.

Procedure

  1. Make preparation for this task.
    1. Remove the server cover. See Remove the server cover.
      Attention
      The heat sink and processor could be very hot. To avoid burning yourself, wait for a few minutes after turning off the server before you remove the server cover.
    2. Disconnect the cables from the drive assembly.
  2. Remove the bay 2+bay 3 drive cage assembly from the chassis.
    1. Rotate the handle on the bay 3 drive cage.
    2. Lift the bay 2+bay 3 drive cage assembly out from the chassis.
      Figure 1. Removing the bay 2+bay 3 drive cage assembly
      Removing the bay 2+bay 3 drive cage assembly
  3. Remove the 3.5-inch drive from the bay 3 drive cage. See Remove a simple-swap drive (bay 3).
  4. Remove the bay 3 drive cage from the bay 2 drive cage.
    1. Remove the screw that secures the bay 3 drive cage to the bay 2 drive cage. Reserve the screw to be used for reinstalling the bay 3 drive cage.
    2. Slide the bay 3 drive cage to separate it from the bay 2 drive cage.
    Figure 2. Removing the bay 3 drive cage
    Removing the bay 3 drive cage

After you finish

  1. Install a replacement unit. See Install the drive cage (bay 3).

  2. If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.