Install the optical drive cage

Follow this procedure to install the optical drive cage.

S002

CAUTION

The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

S006

CAUTION

When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or transmitters) are installed, note the following:

• Do not remove the covers. Removing the covers of the laser product could result in exposure to hazardous laser radiation. There are no serviceable parts inside the device.
• Use of controls or adjustments or performance of procedures other than those specified herein might result in hazardous radiation exposure.

Procedure

1. Make sure the cage bar is installed in the chassis. To install the cage bar, see Install the server cover.
2. If necessary, install the 3.5-inch drive assembly to the optical drive cage. See Simple-swap drive and drive cage replacement (bay 3).
3. Install the optical drive cage.
   1. Align the four pins on the sides of the optical drive cage with the four slots on the chassis and cage bar; then, lower the optical drive cage into the chassis.
   2. Ensure the optical drive cage is seated correctly; then, rotate the optical drive cage handle toward the front of the chassis to secure the optical drive cage into place.
      Figure 1. Installing the optical drive cage
      
      
4. If applicable, connect the signal and power cable of the 3.5-inch drive to the system board, see Internal cable routing.