Skip to main content

IP Address Firewall Rules

Click System Firewall > IP Address Firewall Rules.

The IP Firewall Rules page is displayed, including the following:

Existing IP Rules​

A blank page will be opened if you did not add anything in Add IP Rule. If there is no IP rule, add an IP rule by clicking the Add IP Rule link.

After you have configured IP rules, all the configured IP rules will be displayed on the Existing IP Rules page. To view this page, you must at least be an operator. Only administrators can add or delete an IP rule.

Note

Click Icon for deleting an item in the upper right corner to delete an item.

Add New IP Rule​

To add an IP rule, perform the following steps:

  1. Click IP Address Firewall Settings > Add New IP Rule.

    The Add IP Rule page is displayed.

  2. Enter an IP address or the start value of a range of IP addresses in the IP Single (or) Range Start field.

    Note

    • An IP address consists of 4 numbers separated by dots, as in “xxx.xxx.xxx.xxx”.

    • Each number ranges from 0 to 255.

    • The first number must not be 0.

  3. (Optional) Enter the end value of the IP range in the IP Range End field.

  4. Select Enable Timeout to enable firewall rules with timeout.

  5. Enter Start Date and Start Time to start the respective firewall rule effect from this date and time.

  6. Enter End Date and End Time to end the respective firewall rule effect from this date and time.

  7. Determine the rule to Block or Allow.

  8. Click Save to save the settings.