Skip to main content

General Firewall Settings

Click System Firewall > General Firewall Settings.

The General Firewall Settings page is displayed, including the following:

Existing Firewall Settings​

A blank page will be opened if you did not add anything in Add Firewall Settings. If there are no firewall settings, add firewall settings by clicking the Add Firewall Settings link.

After you have configured firewall settings, all the configured firewall settings will be displayed on the Existing Firewall Settings page. To view this page, you must at least be an operator. Only administrators can add or delete a firewall.

Note

Click Icon for deleting an item in the upper right corner to delete an item.

Add Firewall Settings​

To add firewall settings, perform the following steps:

  1. Click General Firewall Settings > Add Firewall Settings.

    The Add Firewall Settings page is displayed.

  2. Select Block All to block all the incoming IP addresses and ports.

  3. Select Flush All to flush all the system firewall rules (read-only). After you select this check box, the other fields cannot be configured. Then click Save to save the settings.

  4. Select Timeout to enable firewall rules with timeout.

  5. Enter Start Date and Start Time to start the respective firewall rule effect from this time.

  6. Enter End Date and End Time to end the respective firewall rule effect from this time.

  7. Click Save to save the settings.