Removing a memory module

To remove a dual inline memory module (DIMM) on 4U server models with non-hot-swap power supplies, complete the following steps. For the 5U server model with hot-swap power supplies (Model name: 2582-F4x), please see the next sub-section.

1. Read the safety information in Safety and Installation guidelines.
2. Turn off the server and all attached devices; then, disconnect all power cords and external cables.
3. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
   Attention

   Do not allow the server to fall over.
4. Remove the side cover (see Removing the side cover).
5. Remove the air duct.
6. Locate the DIMM connector that contains the DIMM that is to be replaced (see System-board internal connectors).
   Attention

   To avoid breaking the DIMM retaining clips or damaging the DIMM connectors, open and close the clips gently.
7. Carefully open the retaining clips on each end of the DIMM connector and remove the DIMM.
   
   
8. If you are instructed to return the DIMM, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

To remove a dual inline memory module (DIMM) on the 5U server model with hot-swap power supplies (Model name: 2582-F4x), complete the following steps. For 4U server models with non-hot-swap power supplies, please see the above sub-section.

1. Read the safety information in Safety and Installation guidelines.
2. Turn off the server and all attached devices; then, disconnect all power cords and external cables.
3. Unlock and remove the side cover (see Removing the side cover).
4. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
   Attention

   Do not allow the server to fall over.
5. Locate the DIMM connector that contains the DIMM that is to be replaced (see System-board internal connectors).
   Attention

   To avoid breaking the DIMM retaining clips or damaging the DIMM connectors, open and close the clips gently.
6. Carefully open the retaining clips on each end of the DIMM connector and remove the DIMM.
   
   
7. If you are instructed to return the DIMM, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.