Replacing the system battery
Use this information to replace the system battery
The following notes describe information that you must consider when replacing the system-board battery in the server.
- When replacing the system-board battery, you must replace it with a lithium battery of the same type from the same manufacturer.
- To order replacement batteries, call 1-800-426-7378 within the United States, and 1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada, call your IBM marketing representative or authorized reseller.
- After you replace the system-board battery, you must reconfigure the server and reset the system date and time.
- To avoid possible danger, read and follow the following safety statement.
![](d3mm9sym.jpg)
When replacing the lithium battery, use only IBM Part Number 33F8354 or an equivalent type battery recommended by the manufacturer. If your system has a module containing a lithium battery, replace it only with the same module type made by the same manufacturer. The battery contains lithium and can explode if not properly used, handled, or disposed of.
- Throw or immerse into water
- Heat to more than 100°C (212°F)
- Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
To install the replacement battery on 4U server models with non-hot-swap power supplies, complete the following steps. For the 5U server model with hot-swap power supplies (Model name: 2582-F4x), please see the next sub-section.
- Follow any special handling and installation instructions that come with the replacement battery.
- Insert the battery:
- Hold the battery in a vertical orientation so that the smaller side is facing the socket.
- Tilt the battery and slide the battery into its socket; then, press the battery toward the socket until it clicks into place. Make sure that the battery clip holds the battery securely.
- Install the air duct.
- Install the side cover (see Replacing the side cover).
- Stand the server back up in its vertical position.
- Reconnect the external cables and power cords; then, turn on the attached devices and turn on the server.
- Start the Configuration/Setup Utility program and reset the configuration:
- Set the system date and time.
- Set the power-on password.
- Reconfigure the server.
To install the replacement battery on the 5U server model with hot-swap power supplies (Model name: 2582-F4x), complete the following steps. For 4U server models with non-hot-swap power supplies, please see the above sub-section.
- Follow any special handling and installation instructions that come with the replacement battery.
- Insert the battery:
- Orient the battery so that the positive side faces up.
- Tilt the battery and slide the battery into its socket.
- Press the battery down into the socket until it clicks into place. Make sure that the battery clip holds the battery securely.
- Stand the server back up in its vertical position.
- Install and lock the side cover (see Replacing the side cover).
- Reconnect the external cables and power cords; then, turn on the attached devices and turn on the server.
- Start the Configuration/Setup Utility program and reset the configuration:
- Set the system date and time.
- Set the power-on password.
- Reconfigure the server.