Installing the bezel assembly

Use this information to install a bezel assembly in the blade server.

Note

1. The following illustration shows how to install a bezel assembly in a blade server.
2. The illustrations in this document might differ slightly from your hardware.

To install the bezel assembly, complete the following steps.

1. Before you begin, read Safety and Installation guidelines.
2. If the blade server is installed in a BladeCenter® unit, remove it (see Removing the blade server from the BladeCenter unit for instructions).
3. Carefully lay the blade server on a flat, static-protective surface.
4. Open the blade server cover (see Removing the blade server cover for instructions).
5. If an optional expansion unit is installed, remove it (see Removing an optional expansion unit).
6. Connect the control-panel cable to the control-panel connector on the system board.
7. Carefully slide the bezel assembly onto the blade server until it clicks into place.
8. Install the expansion unit, if you removed one from the blade server to remove the bezel (see Installing an optional expansion unit).
9. Install the cover onto the blade server (see Installing the blade server cover).
10. Install the blade server into the BladeCenter unit (see Installing the blade server in a BladeCenter unit.