Removing and replacing Tier 2 CRUs
You may install a Tier 2 CRU yourself or request IBM to install it, at no additional charge, under the type of warranty service that is designated for the server.
- Removing the scalability tray
To remove the scalability tray from a blade server, complete the following steps. - Installing the scalability tray
Use this information to install the scalability tray on a blade server. - Removing the 1-node speed burst card
Use this information to remove the 1-node speed burst card from a blade server. - Installing the 1-node speed burst card
Use this information to install a 1-node speed burst card in a blade server. - Removing the 2-node scalability card
Use this information to remove the 2-node scalability card from a blade server. - Installing the 2-node Scalability card
Use this information to install the 2-node scalability card on a blade server. - Removing an IBM MAX5 expansion blade
Use these instructions to remove an IBM MAX5 expansion blade from the BladeCenter HX5 blade server. - Installing an IBM MAX5 expansion blade
Use these instructions to install an IBM MAX5 expansion blade. - Removing the IBM MAX5 1-node Scalability card
Use this information to remove the IBM MAX5 1-node scalability card from a blade server. - Installing the IBM MAX5 1-node Scalability card
Use this information to install the IBM MAX5 1-node scalability card on a blade server. - Removing an expansion unit
Use these instructions to remove an expansion unit from a blade server or from the topmost blade server in a scalable blade complex. - Installing an expansion unit
Use these instructions to install an expansion unit or for the topmost blade server in a scalable blade complex. - Removing an SSD expansion card
Use this information to remove an SSD expansion card. - Installing an SSD expansion card
Use this information to install an SSD expansion card. - Removing a solid state drive
Use this information to remove a solid state drive. - Installing a solid state drive
Use this information to install a solid state drive. - Removing a DIMM - BladeCenter HX5
Use this information to remove a dual inline memory module (DIMM) from the blade server. - Installing a DIMM - BladeCenter HX5
The blade server has a total of 16 dual inline memory module (DIMM) connectors. The blade server supports very low profile (VLP) DDR3 DIMMs with error code correction (ECC) in 2 GB, 4 GB, 8 GB, 16 GB, and 32 GB capacities. - Removing a DIMM - IBM MAX5 expansion blade
Use this information to remove a dual inline memory module (DIMM) from the IBM MAX5 expansion blade. - Installing a DIMM - IBM MAX5
The expansion blade has a total of 24 dual inline memory module (DIMM) connectors. The expansion blade supports 2 GB (Type 7873 models), 4 GB, 8 GB, 16 GB (Type 7873 models), and 32 GB (Type 7873 models) memory DIMMs. Typically, you will install all memory supported by the BladeCenter HX5 blade server before installing memory in the IBM MAX5 expansion blade. - Removing a hypervisor key
Use this information to remove a hypervisor key from the blade server. - Installing a hypervisor key
Use these instructions to install a hypervisor key in the blade server. - Removing an I/O expansion card
- Installing an I/O expansion card
- Removing the control panel
Use this information to remove the control panel from the blade server. - Installing the control panel
Use these instructions to install the control panel in the blade server.
Give documentation feedback