ping command errors

This topic lists errors for the ping command.

See Common errors for a list of error messages that apply to all commands. See ping command for information about command syntax and examples of command use.

Table 1. ping command errors.
The error table is a multi-row, two-column table where each row describes a CMM CLI command error: column one lists the error reported by the command-line interface and column two describes what the error means.
Error message	Definition
Error reading network configuration	An error occurs while the CMM is reading the network configuration.
Index index IP address not found where the index an IP address in an index table.	The user tries to specify an IP address index number that is not in the index table.
Index is greater than the current number of available IP addresses. Please try again.	The user tries to specify an IP address index number that is not in the index table.
IP address ip_address not found where the ip_address identifies the invalid IP address argument.	The user tries to specify an IP address that is not valid.
Not supported by this type of I/O module. Type env -h for help on changing targets.	The user tries to issue a command that is not valid for the command target.
The I/O module cannot be pinged while the IP config is protected.	The user tries to ping a protected member of an I/O module stack.
This command is not available for switches when protected mode is active	A user tries to ping an I/O module that is operating in protected mode.

Give documentation feedback