service command errors
This topic lists errors for the service command.
See Common errors for a list of error messages that apply to all commands. See service command for information about command syntax and examples of command use.
Error message | Definition |
---|---|
Firmware update is in progress. Try again later, or use the -o flag to override this warning. | A user tries to run a command while the CMM is busy. Run the command using the -o command option to override this warning. |
Getting status of debug with USB key failed. | An error occurs while the CMM is reading the status of debug with a USB key. |
Invalid option for this blade: -hard". | The user tries to perform a hard restart on a compute node that does not support the hard restart option. |
Invalid option for this target: - option where option identifies the illegal command option that was entered. | The user tries to enter a command option for a target that does not support it. |
Invalid syntax for this target | A user tries to enter a command that is not correct for the specified command target. |
This command cannot be issued right now. The primary CMM is verifying the code level on the standby CMM. Please try again later. | A user tries to perform a virtual reseat (service-level reset) of the primary CMM while it is busy. |
This command cannot be issued right now. The primary CMM is verifying the code level on the standby CMM. Please try again later, or use the -o flag to override this warning. | A user tries to perform a virtual reseat (service-level reset) of the primary CMM while it is busy. Run the command using the -o command option to override this warning. |
This command cannot be issued right now. The standby CMM is flashing, and a reset might result in a failover. Please try again later. | A user tries to perform a virtual reseat (service-level reset) of the primary CMM while the standby CMM is unable to support failover. |
This command cannot be issued right now. The standby CMM is flashing, and a reset might result in a failover. Please try again later, or use the -o flag to override this warning. | A user tries to perform a virtual reseat (service-level reset) of the primary CMM while the standby CMM is unable to support failover. Run the command using the -o command option to override this warning. |
This command cannot be issued right now. There is no standby CMM present. | A user tries to perform a virtual reseat (service-level reset) of the primary CMM when no standby CMM is available to support failover. |
Give feedback