Installing the USB flash drive
Use this information to install the USB flash drive.
Before you install the USB flash drive, complete the following steps:
- Read Safety and Installation guidelines.
- If the compute node is installed in a NeXtScale n1200 Enclosure, remove it (see Removing a compute node from a chassis for instructions).
- Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with the bezel pointing toward you.
This component can be installed as an optional device or as a CRU. The installation procedure is the same for the optional device and the CRU.
To install the USB flash drive, complete the following steps.
Figure 1. Installing USB flash drive
- Remove the cover (see Removing the compute node cover).
- Locate the USB connector on the system-board (see System-board internal connectors).
- Push the USB flash drive into the connector.
After you install the USB flash drive, complete the following steps:
- Install the cover onto the compute node (see Installing the compute node cover for instructions).
- Install the compute node into the chassis (see Installing a compute node in a chassis for instructions).
Give documentation feedback