Install hardware options in the compute node
Use the following information to remove and install the options in the compute node.
- Remove a compute node from the enclosure
Use this procedure to remove a compute node from the D2 Enclosure. - Remove the compute node cover
Use this procedure to remove the compute node cover. - Remove the air baffle
Use this procedure to remove the air baffle. - Remove the M.2 backplane
Use this information to remove the M.2 backplane. - Install an M.2 drive in the M.2 backplane
Use this information to install an M.2 drive in the M.2 backplane. - Install the KVM breakout module
Use this information to install the KVM breakout module. - Install a hot-swap drive
Use this information to install a hard disk drive. - Install a memory module
The following notes describe the types of DIMMs that the node supports and other information that you must consider when you install DIMMs. - Install a RAID adapter into the compute node
Use this information to install a RAID adapter into the compute node. - Install the M.2 backplane
Use this information to install the M.2 backplane. - Install a processor-heat-sink module
The processor and heat sink are removed together as part of a processor-heat-sink-module (PHM) assembly. PHM installation requires a Torx T30 driver. - Install the air baffle
Use this procedure to install the air baffle. - Install the compute node cover
Use this procedure to install the compute node cover. - Install a compute node in the enclosure
Use this procedure to install a compute node in the D2 Enclosure.
Give documentation feedback