Skip to main content

Install a DIMM comb

Use this information to install a DIMM comb.

About this task

Attention
Note
The following illustration might differ slightly from your hardware, but the installation method is the same.

Procedure

  1. Align the DIMM comb with the slots and insert it into the node.
    Figure 1. DIMM comb installation
    DIMM comb installation
  2. Install the memory module tool to the DIMM comb.
    Figure 2. Memory module tool
    Memory module tool
After you finish

  1. Install the tray cover. See Install the tray cover.

  2. Install the tray into the enclosure. See Install a DWC tray in the enclosure.

  3. Connect all required external cables to the solution.
    Note
    Use extra force to connect QSFP cables to the solution.

  4. Check the power LED on each node to make sure it changes from fast blink to slow blink to indicate all nodes are ready to be powered on.

Demo video

Watch the procedure on YouTube