Skip to main content

Install a drive cage assembly

Use this information to install a drive cage assembly.

About this task

Required tools

You may need the SD665-N V3 Water Loop Gap Pad Kit to properly replace the component.

Attention
Important
Gap pad/putty pad replacement guidelines

  • To identify the gap pad/putty pad location and orientation, see:

  • Before replacing the gap pad/putty pad, gently clean the interface plate or the hardware surface with an alcohol cleaning pad.

  • Hold the gap pad/putty pad carefully to avoid deformation. Make sure no screw hole or opening is blocked by the gap pad/putty pad material.

  • Do not use expired putty pad. Check the expiry date on putty pad package. If the putty pads are expired, acquire new ones to properly replace them.

Firmware and driver download: You might need to update the firmware or driver after replacing a component.

Procedure

  1. Make sure the blank bezel fillers are installed. If not, install them to the node.
    Figure 1. Blank bezel filler installation
    Blank bezel filler installation
  2. If the gap pad located on the reverse side of the drive cage is damaged or missing, replace it with a new one. Make sure to follow Gap pad/putty pad replacement guidelines.
    Figure 2. Gap pad location
    Gap pad location
  3. If the drive cage gap pad is damaged or missing, replace it with a new one. See the following for the gap pad location for each drive cage. Make sure to follow Gap pad/putty pad replacement guidelines.
    Note
    Align the gap pad with marking on water loop when attaching gap pad.
    Figure 3. Markings on water loop for gap pad alignment
    Markings on water loop for gap pad alignment
    Figure 4. Replacing gap pad
    Replacing gap pad
  4. Install the drive cage assembly.
    1. Install the drive assembly into the node.
    2. Secure the 3 screws.
    Note
    The following illustration might differ slightly from your hardware, but the installation method is the same.
    Figure 5. One 7 mm drive cage assembly installation
    One 7 mm drive cage assembly installation
    Figure 6. Two 7 mm drive cage assembly installation
    Two 7 mm drive cage assembly installation
  5. Connect the drive cage assembly cable to the system board. For more information, see .
    Figure 7. Connecting drive cage cables
    Disconnecting drive cable
    Table 1. Drive assembly cable routing
    CableFromTo
    1Drive cage assemblyPCIe 2/SATA connector on system board.
After you finish

  1. Install the cross braces. See Install the cross braces.

  2. Install the tray cover. See Install the tray cover.

  3. Install the tray into the enclosure. See Install a DWC tray in the enclosure.

  4. Connect all required external cables to the solution.
    Note
    Use extra force to connect QSFP cables to the solution.

  5. Check the power LED on each node to make sure it changes from fast blink to slow blink to indicate all nodes are ready to be powered on.

Demo video

Watch the procedure on YouTube