Skip to main content

Install the flash power module

Use this information to install the flash power module.

About this task

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Attention
  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.

  • If the server is installed in a rack, remove the server from the rack.

  • Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

Procedure

Install the flash power module.
Figure 1. Flash power module installation
Flash power module installation
  1. Insert the end of the flash power module into its carrier.
  2. Rotate the flash power module down into the carrier until the tab clicks in place to secure it.

After you finish

  1. Connect the flash power module cable to the RAID adapter. See Flash power module cable routing.

  2. Install the top cover. See Install the top cover.

  3. Complete the parts replacement. See Complete the parts replacement.

Demo video

Watch the procedure on YouTube