Install the VGA cable (2.5-inch drive model)
Use this information to install the VGA cable for the 2.5-inch drive model.
About this task
S002
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Attention
Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
Power off the server and peripheral devices and disconnect the power cords and all external cables. See Power off the server.
If the server is installed in a rack, remove the server from the rack.
Procedure
Install the VGA cable.
Figure 1. VGA cable installation
Insert the VGA cable into the front I/O module.
Install and fasten two screws to secure the VGA cable.
After you finish
Connect the VGA cable to the system board. See Front I/O module cable routing.
Install the top cover. See Install the top cover.
Complete the parts replacement. See Complete the parts replacement.
Demo video
Give documentation feedback