Skip to main content

Install the OSFP port card

Follow instructions in this section to install the OSFP port card.

About this task

Attention
  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
  • Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

Procedure

  1. Align the OSFP port card with the chassis; then, press the OSFP port card into the slot on the chassis until it is fully seated.
  2. Fasten the screw to secure the OSFP port card to the chassis.
    Figure 1. OSFP port card installation
    OSFP port card installation

After you finish

  1. Reconnect the cables to the CX-7 carrier board and the CX-7 mezz board. See OSFP port card cable routing for more information.
    CAUTION
    • Hold the cable connector at 45 degree angle when inserting it into the port.
    • Have extremely precaution when reseating the connectors that have a 45 degree label on them as they are fragile and will get damage if not installed in the correct 45 degree angle.

  2. Equally divide the cables that go through the right side of the front drive tray into two bundles, and secure them with the two cable ties.
    Figure 2. Securing cables with cable ties
    Securing cables with cable ties
  3. Complete the parts replacement. See Complete the parts replacement.

Demo video

Watch the procedure on YouTube