Skip to main content

Remove the CX-7 assembly

Follow instructions in this section to remove the CX-7 assembly. The procedure must be executed by a trained technician.

About this task

Attention

Procedure

  1. Make preparation for this task.
    1. Remove the top cover. See Remove the top cover.
    2. Disconnect the cables that are connected to the CX-7 carrier board and the CX-7 mezz board.
      CAUTION
      • Hold the cable connector at 45 degree angle when inserting it into the port.
      • Have extremely precaution when reseating the connectors that have a 45 degree label on them as they are fragile and will get damage if not installed in the correct 45 degree angle.

      • There is a latch on the power cable connected to the power connector 2 on the CX-7 carrier board. Slightly press and hold the cable latch; then, disconnect the cable from the CX-7 carrier board.
        Figure 1. Power cable disconnection
        Power cable disconnection
  2. Remove the CX-7 assembly.
    1. Loosen the thumbscrew that secures the CX-7 assembly to the front drive tray.
    2. Rotate the CX-7 carrier board handle up.
    3. Press down the rubber pad on the CX-7 carrier board handle so that the rubber pad is located underneath the front drive tray handle.
    4. Push the CX-7 carrier board handle toward the interposer card to disconnect the CX-7 assembly from the interposer card.
      Note
      Make sure the two retention clips are in the slots on the interposer card before pushing the CX-7 carrier board handle.
    5. Release the two retention clips from the slots on the interposer card; then, rotate the CX-7 carrier board handle down so that the rubber pad is facing up.
    6. Slightly slide the CX-7 assembly backward; then, hold the CX-7 carrier board handle and the CX-7 carrier board tab, and lift CX-7 assembly out from the chassis.
      Figure 2. CX-7 assembly removal
      CX-7 assembly removal

      CX-7 assembly removal
      1 CX-7 carrier board handle2 CX-7 carrier board tab

After you finish

If you are instructed to return the component or optional device, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

Demo video

Watch the procedure on YouTube