Skip to main content

Install the server cover

Follow instructions in this section to install the top cover.

About this task

To avoid potential danger, read and follow the following safety statements.
  • S002
    disconnect all power
    CAUTION
    The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
  • S014
    shock hazard
    CAUTION
    Hazardous voltage, current, and energy levels might be present. Only a qualified service technician is authorized to remove the covers where the label is attached.
  • S033
    240VA shock hazard
    CAUTION

    Hazardous energy present. Voltages with hazardous energy might cause heating when shorted with metal, which might result in spattered metal, burns, or both.

Attention

  • Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.

  • Ensure that all adapters and other components are installed and seated correctly and that you have not left loose tools or parts inside the server.

  • Ensure that all internal cables are correctly routed. See Internal cable routing.

  • If you are installing a new server cover, attach the service label to the inside of the new server cover first if necessary.

    Note
    A new server cover comes without a service label attached. If you need a service label, order it together with the new server cover. The service label is free of charge.

Procedure

  1. Install the server cover.
    1. Align the tabs on the server cover with the corresponding slots on the top edge of the chassis.
    2. Pivot the server cover to close it.
      Figure 1. Positioning the server cover onto the chassis
      Installing the server cover
      Note
      Before sliding the cover forward, ensure that all the tabs on the over align to the slots and engage the chassis properly.
  2. Secure the server cover to the chassis.
    1. Slide the server cover towards the front of the chassis until it stops.
    2. Tighten the thumbscrew with a screwdriver to secure the server cover.
    Figure 2. Securing the server cover to the chassis

After you finish

Complete the parts replacement. See Complete the parts replacement.

Demo video

Watch the procedure on Youtube