Skip to main content

Install the thermal sensor

Follow instructions in this section to install the thermal sensor.

About this task

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.
Attention
  1. Read Installation Guidelines and Safety inspection checklist to ensure that you work safely.
  2. Touch the static-protective package that contains the component to any unpainted metal surface on the server; then, remove it from the package and place it on a static-protective surface.

Procedure

  1. Install the thermal sensor.
    1. From the inside of the chassis, attach the end of the thermal sensor to the corresponding slot on the front of the chassis.
    2. From the inside of the chassis, push the thermal sensor into the slot.
    3. Make sure the thermal sensor is secured in place.
      Figure 1. Installing the thermal sensor
      Installing the thermal sensor
  2. Connect the thermal sensor cable to the system board. See Internal cable routing.
After you finish

  1. If an M.2 drive was removed, reinstall the M.2 drive. See Install an M.2 drive.

    Note
    The thermal sensor cable should be placed under the M.2 drive.

  2. Reinstall the front fan. See Install the fan (front and rear).

  3. Reinstall the front bezel. See Install the front bezel.

  4. Complete the parts replacement. See Complete the parts replacement.

Demo video

Watch the procedure on YouTube