Skip to main content

Install the M.2 drive retainer

Follow this procedure to install the M.2 drive retainer.

S002
disconnect all power
CAUTION
The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

About this task

Attention
Watch the procedure
  • A video of this procedure is available at YouTube.

After you finish

Align the M.2 drive retainer with the three slots on chassis, and lower the retainer into the chassis; then, slide the retainer toward the 2.5-inch drive to secure it in place.
Figure 1. Installing the M.2 drive retainer
Installing the M.2 drive retainer
After you finish

  1. Install an M.2 drive, see Install an M.2 drive.

  2. If necessary, reinstall the 2.5-inch drive to the drive bay 2, see Install a simple-swap drive (bay 1-2).

  3. Proceed to complete the parts replacement, see Complete the parts replacement.