Remove the processor (trained technician only)

Follow this procedure to remove the processor. This procedure must be executed by a trained technician.

S002

CAUTION

The power-control button on the device and the power switch on the power supply do not turn off the electrical current supplied to the device. The device also might have more than one power cord. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source.

Procedure

1. Make preparation for this task.
   1. Remove the server cover, see Remove the server cover.
      Note

      The heat sink and processor could be very hot. To avoid burning yourself, wait for a few minutes after turning off the server before you remove the server cover.

   2. If applicable, remove the optical drive cage, see Remove the optical drive cage.
   3. Remove the heat sink and fan module, see Remove the heat sink and fan module (trained technician only).
2. Remove the processor.
   1. Gently pull the handle away from the processor retainer.
   2. Lift the handle along with the retainer to the fully open position.
   3. Hold the processor by both sides and gently lift it away from the processor socket.
      Attention

      1. Do not touch the gold contacts on the bottom of the processor.

      2. Keep the processor socket clean from any object to prevent possible damages.

      Figure 1. Removing the processor