Install the hot-swap power supply cage

Use this information to install the hot-swap power supply cage.

Read the installation Guidelines

Power off the server for this task

ATTENTION: Static Sensitive Device Ground package before opening

Before installing the hot-swap power supply cage, touch the static-protective package that contains the new hot-swap power supply cage to any unpainted surface on the outside of the server. Then, take the new cage out of the package and place them on a static-protective surface.

To install the hot-swap power supply cage, complete the following steps:

Figure 1. Hot-swap power supply cage installation

1. Slide the new hot-swap power supply cage into the bay as shown until it snaps into position.
2. Install the screws to secure the hot-swap power supply cage.