3.5-inch drive cable routing
See this topic to learn how to do cable routing for server models with 3.5-inch drive backplanes.
Complete the following routing for power cables corresponding to the backplanes that are installed in the system.
 | From (backplane) to power distribution board | Length | |
| 4 BP4 | BP4 power connector | 160 mm | |
| 3 BP3 | BP3 power connector | 355 mm | |
| 2 BP2 | BP2 power connector | ||
| 1 BP1 | BP1 power connector | 455 mm | |
Then, proceed to the table of combinations that correspond to the system configuration:
Note
* Depending on the configurations, the server might come with either the 3.5-inch BP4 or the ODD/Tape drive cage.
For server models with the 3.5-inch BP4, there is no ODD/Tape drive cage.
For server models with the ODD/Tape drive cage, there is no 3.5-inch BP4.
See Front view for different sever models.
Pure SAS/SATA combinations
Pure NVMe combinations
| BP4 (without ODD/Tape drives)*1 | BP3 | BP34 (without ODD/Tape drives)*1 | BP23 | BP234 (without ODD/Tape drives)*1 | BP123 | BP1234 (without ODD/Tape drives)*1 | |
|
|
|
|
|
|
| BP4 (or ODD/Tape drive cage) |
|
|
|
|
|
| BP3 | |
|
|
|
| BP2 | |||
|
| BP1 | |||||
Mixed combinations
| BP124 (without ODD/Tape drives)*1 | BP123 | BP124 (without ODD/Tape drives)*1 | BP123 | BP1234 (without ODD/Tape drives)*1 | BP1234 (without ODD/Tape drives)*1 | BP1234 (without ODD/Tape drives)*1 | |
|
|
|
|
|
|
| BP4 (or ODD/Tape drive cage) |
|
|
|
|
| BP3 | ||
|
|
|
|
|
|
| BP2 |
|
|
|
|
|
|
| BP1 |
Give documentation feedback