Skip to main content

Network Bond Configuration

This section is used to configure the network bonding settings for the network interfaces.

To open the Network Bond Configuration page, click Settings > Network Settings > Network Bond Configuration.

The fields of the Network Bond Configuration page are explained below.
  • Enable Bonding: This option is used to enable or disable bonding for the network interfaces.
    Note

    If VLAN is enabled for either slave interface, then bonding cannot be enabled. VLAN can be disabled under Settings > Network Settings > Network IP Settings.

  • Auto Configuration: This option is used to enable or disable automatic interface configuration.
    Note

    • If this option is enabled, all the services will restart automatically.

    • If this option is disabled, the interfaces in service can be configured via IPMI commands.

  • Bond Interface: This option is used to configure bonding for the network interfaces.
    Note

    A minimum of two network interfaces is required to enable network bonding for the device.

  • Bond Mode: This field displays the network bonding mode and cannot be configured.

  • Save: Save the settings.