Removing the hot-swap power supply cage

To remove the hot-swap power-supply cage on the 5U server model with hot-swap power supplies (Model name: 2582-F4x), complete the following steps.

1. Read the safety information in Safety and Installation guidelines.
2. Turn off the server and all attached devices; then, disconnect all power cords and external cables.
3. Unlock and remove the side cover (see Removing the side cover).
4. Remove the hot-swap power supplies (see Removing the hot-swap power supply).
5. Carefully turn the server on its side so that it is lying flat, with the system board facing up.
   Attention

   Do not allow the server to fall over.
6. Disconnect the cables from the power-supply cage to the system board and all internal components.
7. Remove the two screws that secure the power-supply cage to the chassis; the two screws are located in the front of the hot-swap power supply cage.
   
   
8. Remove the other four screws that also secure the power-supply cage to the chassis; then, slide the cage toward the front of the server to disengage the retaining clips from the top of the chassis and lift the cage out of the chassis.
   
   
9. If you are instructed to return the power-supply cage, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.