Skip to main content

Hard disk drive installation

The following illustrations show the location of the drive bays in the server. Your hardware might differ, depending on the model.

Depending on the server model, the server might come with a SATA attached DVD-ROM drive in bay 1.

Note
If the server is configured for RAID operation using a ServeRAID adapter, you might have to reconfigure your disk arrays after you install drives. See the ServeRAID adapter documentation for additional information about RAID operation and complete instructions for using the ServeRAID adapter.

The following illustrations show the location of the drive bays in the 2.5-inch hot-swap hard disk drive server models.

Figure 1. Server with eight 2.5-inch hot-swap hard disk drives
Server with eight 2.5-inch hot-swap hard disk drives
Figure 2. Server with sixteen 2.5-inch hot-swap hard disk drives
Server with sixteen 2.5-inch hot-swap hard disk drives
Figure 3. Server with twenty-four 2.5-inch hot-swap hard disk drives
Server with twenty-four 2.5-inch hot-swap hard disk drives
Figure 4. Server with thirty-two 2.5-inch hot-swap hard disk drives
Server with thirty-two 2.5-inch hot-swap hard disk drives

The following illustrations show the location of the drive bays in the 3.5-inch simple-swap or hot-swap hard disk drive server models.

Figure 5. Server with six 3.5-inch hot-swap hard disk drives
Server with six 3.5-inch hot-swap hard disk drives
Figure 6. Server with twelve 3.5-inch hot-swap hard disk drives
Server with twelve 3.5-inch hot-swap hard disk drives
Figure 7. Server with eight 3.5-inch simple-swap hard disk drives
Server with eight 3.5-inch simple-swap hard disk drives

The following illustrations show the location of the drive bays in the 2.5-inch and 3.5-inch hot-swap or hot-swap hard disk drive server models.

Figure 8. Server with six 3.5-inch hot-swap and eight 2.5-inch hot-swap hard disk drives
Server with six 3.5-inch hot-swap and eight 2.5-inch hot-swap hard disk drives
Figure 9. Server with six 3.5-inch hot-swap and sixteen 2.5-inch hot-swap hard disk drives
Server with six 3.5-inch hot-swap and sixteen 2.5-inch hot-swap hard disk drives
The following notes describe the types of drives that the server supports and other information that you must consider when installing a drive:
  • Make sure that you have all the cables and other equipment that is specified in the documentation that comes with the drive.
  • Check the instructions that come with the drive to see whether you have to set any switches or jumpers on the drive. If you are installing a SAS or SATA device, be sure to set the SAS or SATA ID for that device.
  • Optional external tape drives and DVD-ROM drives are examples of removable-media drives. You can install removable-media drives only in bays 1 and 2 on models with six, twelve 3.5-inch, eight, sixteen, twenty-four, and thirty-two 2.5-inch hard disk drives.
  • The electromagnetic interference (EMI) integrity and cooling of the server are protected by having all bays and PCIe slots covered or occupied. When you install a drive or PCI adapter, save the EMC shield and filler panel from the bay or the PCI adapter slot cover in the event that you later remove the drive or adapter.
  • For a complete list of supported options for the server, see the Lenovo ServerProven website.