Skip to main content

Removing the air baffle

Use this information to remove the air baffle from the server.

When you work with some optional devices, you must first remove the air baffle to access some components or connectors on the system board. The following illustration shows how to remove the air baffle.

To remove the air baffle, complete the following steps:

  1. Read the safety information that begins on page Safety and Installation guidelines.
  2. Turn off the server (see Turning off the server) and all attached peripheral devices. Disconnect all power cords; then, disconnect all external cables from the server.
  3. Remove the top cover (see Removing the server top cover).
  4. Rotate the hot-swap rear hard disk drive cage up (see Rotating the hot-swap rear hard disk drive cage up.
  5. Grasp the top of the air baffle and lift it out of the server.
    Attention
    For proper cooling and airflow, replace the air baffle before you turn on the server. Operating the server with the air baffle removed might damage server components.
    Figure 1. Air baffle removal
    Air baffle removal

If you have other devices to install or remove, do so now. Otherwise, go to Completing the installation.