Installing an optional CD/DVD drive

Use this information to install a CD/DVD drive.

1. Read the safety information and installation guidelines, see Safety and Installation guidelines.
2. Turn off the server (see Turning off the server) and all attached peripheral devices. Disconnect all power cords; then, disconnect all external cables from the server.
3. Remove the top cover (see Removing the server top cover).
4. Locate the blue release tab on the rear of the CD/DVD drive bay; then, while you press the tab, push the CD/DVD filler toward the front of the server.
   
5. Pull the CD/DVD drive filler out of the front of the server.
6. Touch the static-protective package that contains the new optical drive to any unpainted metal surface on the server; then, remove the optical drive from the package and place it on a static-protective surface.
7. Remove the retention clip from the side of the drive filler.

   

   Note

   If you are installing a drive that contains a laser, observe the following safety precaution.

   Statement 3
   
   

   CAUTION

   When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or transmitters) are installed, note the following:

   • Do not remove the covers. Removing the covers of the laser product could result in exposure to hazardous laser radiation. There are no serviceable parts inside the device.
   • Use of controls or adjustments or performance of procedures other than those specified herein might result in hazardous radiation exposure.

   
   
   

   DANGER

   danger

   Some laser products contain an embedded Class 3A or Class 3B laser diode. Note the following.

   Laser radiation when open. Do not stare into the beam, do not view directly with optical instruments, and avoid direct exposure to the beam.

   
   
   
8. Attach the drive retention clip that you removed from the previous drive to the side of the new drive.
   Note

   Be sure to align the bend on the drive retention clip tab with the rear edge of the CD/DVD drive. Your drive might have more mounting holes than what is shown in the illustration. Adjust the retention clip alignment based on your drive.
9. Align the drive in the drive bay and slide the drive into the CD/DVD drive bay until the drive clicks into place.